ASTM E1703_E1703M-10R23
Standard Test Method for Measuring Rut-Depth of Pavement Surfaces Using a Straightedge
| Označení normy: | ASTM E1703_E1703M-10R23 |
| Vydáno: | 01.03.2023 |
| Status: | Active |
| Počet stran: | 2 |
| Sekce: | 04.03 |
| Označení: | gauge; rut; rut-depth; straightedge; |
| ASTM označení: | ASTM E1703/E1703M |
| Nahrazuje: | E1703_E1703M-10R15 |
1.1 This test method describes the procedure for the measurement of the depth of the rut at a chosen location in a pavement surface using a straightedge and a gauge.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.