ASTM E2014-17R25
Standard Guide on Metallographic Laboratory Safety
| Označení normy: | ASTM E2014-17R25 |
| Vydáno: | 01.08.2025 |
| Status: | Active |
| Počet stran: | 9 |
| Sekce: | 03.01 |
| Označení: | chemical spills; ergonomics; etching; fume hoods; grinding; heat treating; metallography; SDS; photography; polishing; radiation; safety; specimen; sulfur printing; X-ray; |
| ASTM označení: | ASTM E2014 |
| Nahrazuje: | E2014-17 |
1.1 This guide outlines the basic safety guidelines to be used in a metallographic laboratory. Safe working habits are discussed for various tasks performed in a metallographic laboratory.
1.2 The sections appear in the following order:
|
| Section |
| Scope | 1 |
| Referenced Documents | 2 |
| Terminology | 3 |
| Significance and Use | 4 |
| General | 5 |
| Heat Treating | 6 |
| Specimen Preparation/Sectioning | 7 |
| Specimen Mounting | 8 |
| Mechanical Grinding/Polishing | 9 |
| Chemical Safety | 10 |
| Electrolytic Polishing/Etching | 11 |
| Sulfur Printing | 12 |
| Laboratory Ventilation/Fume Hoods | 13 |
| Chemical Spills | 14 |
| Photography | 15 |
| X ray/Electron Microscopy | 16 |
| Laboratory Ergonomics | 17 |
| Disposal of Residues | 18 |
| Keywords | 19 |
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.