ASTM E2261_E2261M-17R21
Standard Practice for Examination of Welds Using the Alternating Current Field Measurement Technique
| Označení normy: | ASTM E2261_E2261M-17R21 |
| Vydáno: | 01.11.2021 |
| Status: | Active |
| Počet stran: | 15 |
| Sekce: | 03.03 |
| Označení: | alternating current field measurement; electromagnetic examination; ferromagnetic weld; non-conducting material; weld; |
| ASTM označení: | ASTM E2261/E2261M |
| Nahrazuje: | E2261_E2261M-17 |
1.1 This practice describes procedures to be followed during alternating current field measurement examination of welds for baseline and service-induced surface breaking discontinuities.
1.2 This practice is intended for use on welds in any metallic material.
1.3 This practice does not establish weld acceptance criteria.
1.4 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system might not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.