ASTM F0810-12R24
Standard Specification for Smoothwall Polyethylene (PE) Pipe for Use in Drainage and Waste Disposal Absorption Fields
| Označení normy: | ASTM F0810-12R24 |
| Vydáno: | 01.06.2024 |
| Status: | Active |
| Počet stran: | 4 |
| Sekce: | 08.04 |
| Označení: | drain pipe; fittings; perforated pipe; pipe; polyethylene; under-drain; |
| ASTM označení: | ASTM F810 |
| Nahrazuje: | F0810-12R18 |
This specification covers smoothwall perforated and nonperforated polyethylene (PE) pipe for use in drainage and waste disposal absorption fields. It covers requirements and test methods for workmanship, flattening, dimensions, tolerances, stiffness, perforations, environmental stress cracking, bonding, and impact resistance. Materials for pipe shall be PE compounds which may consist of lubricants, stabilizers, nonpoly(ethylene) resin modifiers, and pigments. Marking, labeling, installation, and quality assurance shall conform to the requirements of this specification.
1.1 This specification covers requirements and test methods for workmanship, flattening, dimensions, tolerances, stiffness, perforations, environmental stress cracking, bonding, and impact resistance for smoothwall perforated and nonperforated polyethylene (PE) pipe, including coextruded and closed profile pipe. Methods of marking are also included.
1.2 This specification includes two stiffness classes, referred to as, “Standard” and “Heavy Duty.”
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes, excluding those in tables and figures, shall not be considered as requirements of this specification.
1.5 The following precautionary caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.