ASTM F2869-24
Standard Practice for Radial Light Truck Tires to Establish Equivalent Test Severity Between a 1.707-m (67.23-in.) Diameter Rotating Roadwheel and a Flat Surface
| Označení normy: | ASTM F2869-24 |
| Vydáno: | 01.11.2024 |
| Status: | Active |
| Počet stran: | 8 |
| Sekce: | 09.02 |
| Označení: | curved to flat surface; endurance; equivalency; flat to curved surface; high speed temperature; LT metric; highway equivalent; radial light truck tire; roadwheel; roadwheel testing; test severity; tire; tire temperature; 67.23-in.; 1.707-m; |
| ASTM označení: | ASTM F2869 |
| Nahrazuje: | F2869-10R16 |
1.1 This practice describes the procedure to create statistical prediction profilers which can be used to identify equivalent test severity conditions between a 1.707-m diameter laboratory roadwheel surface and a flat or highway surface for radial pneumatic light truck (LT) tires.
1.1.1 Tire operational severity, as defined as the running or operational temperature for certain specified internal tire locations, is not the same for these two test conditions. It is typically higher for the laboratory roadwheel at equal load, speed and inflation pressure conditions due to the curvature effect.
1.1.2 The practice applies to specific operating conditions of light truck tires up through load range E for such tires used on vehicles having a gross vehicle weight rating (GVWR) ≤4536 kg (10 000 lb).
1.1.3 The specific operating conditions under which the procedures of the practice are valid and useful are completely outlined in Section 6, (Limitations) of this standard.
1.2 The prediction profilers are based on empirically developed linear regression models obtained from the analysis of a large database that was obtained from a comprehensive experimental test program for roadwheel and flat surface testing of typical radial light truck (LT) tires. See Section 7 and the research report2 for more details.
1.3 For this standard, SI units shall be used, except where indicated.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.