This document applies to light offshore cranes including their supporting pedestals and structures. NOTE The supporting pedestal and structures such as columns and boom rests are covered by this standard to the extent where their main purpose is to support the crane. This document is applicable to light offshore cranes, whose structures are made of steel. The following characteristics distinguish light offshore cranes from other types of offshore cranes: maximum rated capacity 20 tonnes, maximum load moment 300 tm; limitation for off-board lifting operation Hs = 2,0 m and wind speed 15 m/s (3s gust); maximum number of working cycles class U3 (C d" 1,25 × 105) according to EN 13001-1. This document gives requirements for all significant hazards, hazardous situations and events relevant to light offshore cranes, when used as intended and under conditions foreseen by the risk assessment (see Clause 4). This document is not applicable for: a) transportation, assembly, disabling, scrapping or changing the configuration of the crane; b) non-fixed load lifting attachments, i.e. any item between the hook and the load; c) lifting operations in ambient temperatures below "20 °C; d) lifting operations in ambient temperatures above 45 °C; e) lifting operations involving more than one crane; f) accidental loads due to collisions or earthquakes; g) emergency personnel rescue operations (except training); h) subsea lifting operations; i) general purpose offshore cranes, floating cranes and motion compensated cranes. This document is applicable for the lifting of personnel. This document is applicable to light offshore cranes, which are manufactured after the date of approval by CEN of this document.