ASTM C1780-26A
Standard Practice for Installation Methods for Cement-based Adhered Masonry Veneer
| Označení normy: | ASTM C1780-26A |
| Vydáno: | 01.06.2026 |
| Status: | Active |
| Počet stran: | 9 |
| Sekce: | 04.05 |
| Označení: | adhered; backing; cementitious; masonry; mortar; unit; veneer; |
| ASTM označení: | ASTM C1780 |
| Nahrazuje: | C1780-26 |
1.1 This practice is intended to provide accepted procedures to designers and installers of cement-based adhered masonry veneer in residential and commercial construction. This information is meant to complement the specific installation instructions provided by manufacturers of cement-based adhered masonry veneers and recognized building codes, but is not meant to replace them. This practice does not address installation methods or techniques for all materials in the building envelope. This practice covers the installation of cement-based adhered masonry veneer units for application as adhered veneer to exterior and interior walls, columns, landscape structures and other structures suitable to receive adhered veneer. The units included in this practice are manufactured to meet the requirements of Specification C1670/C1670M or C1877. This practice is limited to the installation of units. This practice does not cover all flashing or moisture management requirements. Refer to the applicable building code and project documents for additional flashing and moisture management requirements.
Note 1: The Concrete Masonry & Hardscapes Association (CMHA) publication Installation Guide and Detailing Options for Compliance with ASTM C1780 for Adhered Manufactured Stone Veneer provides generally accepted methods and details for installation and flashing for manufactured stone veneer.
Note 2: This standard was developed for the installation of cement-based adhered veneer units manufactured from wet-cast concrete or dry-cast concrete. Refer to Guide C1242 for installation of adhered natural stone veneer.
1.2 This practice covers installation of cement-based adhered veneer units complying with the prescriptive design requirements for adhered masonry veneers contained in TMS 402-22 and TMS 602-22. Installation using the engineered design method for adhered masonry veneers contained in TMS 402-22 is outside the scope of this practice.
Note 3: Surface preparations other than those provided in Section 7 may require the use of the engineered design provisions of TMS 402-22. Evaluating the shear bond strength of the system may be necessary for such applications. Appendix X1 provides a method using a modified version of Test Method C482 for evaluating shear bond strength of adhered masonry veneers.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 All workmanship and materials related to the installation of cement-based adhered masonry veneer units shall meet the requirements of the contract documents and building code having jurisdiction over the project.
1.5 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.)
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.