ASTM D5763-24E01
Standard Test Method for Oxidation and Thermal Stability Characteristics of Gear Oils Using Universal Glassware
| Označení normy: | ASTM D5763-24E01 |
| Vydáno: | 01.05.2024 |
| Status: | Active |
| Počet stran: | 5 |
| Sekce: | 05.02 |
| Označení: | extreme pressure gear oils; gear oil; lubricants; non-extreme pressure gear oils; oxidation; sludge; universal oxidation/thermal stability test glassware; universal oxidation test; viscosity increase; |
| ASTM označení: | ASTM D5763 |
| Nahrazuje: | D5763-24 |
1.1 This test method covers the determination of the oxidation characteristics of extreme pressure and non-extreme pressure gear oils and includes the quantitative determination of total sludge, viscosity change, and oil loss.
Note 1: While the round-robin tests used ISO VG 220 extreme pressure gear oils for developing precision data, the test method can be extended to other viscosity grades and to non-extreme pressure gear oils. Refer to Classification D2422 for viscosity grades.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.