Cena s DPH / bez DPH
Hlavní stránka>BS 328-4:1983 Drills and reamers Specification for dimensions of reamers
sklademVydáno: 1983-12-30
BS 328-4:1983 Drills and reamers Specification for dimensions of reamers

BS 328-4:1983

Drills and reamers Specification for dimensions of reamers

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
7320 Kč
Anglicky Tisk
Skladem
7320 Kč
Označení normy:BS 328-4:1983
Počet stran:50
Vydáno:1983-12-30
ISBN:0 580 13419 9
Status:Standard
Popis

BS 328-4:1983


This standard BS 328-4:1983 Drills and reamers is classified in these ICS categories:
  • 25.100.30 Drills, countersinks, reamers

This Part of this British Standard specifies the dimensions of the following commonly used types of reamer:

hand reamers

long-flute machine reamers1) with Morse taper shanks

machine chucking reamers1) shell reamers

socket reamers

hand taper pin reamers

machine taper pin reamers

bridge reamers

A method of calculating tolerances for special reamers is given in Appendix A. Appendix B shows the values of certain of the limits of tolerance specified, extracted from BS 4500-1. Appendix C specifies preferred inch sizes of cutting diameters for various types of reamer, and Appendix D shows tables of dimensions set out as functions of reamer diameter, i.e. “general tables”.

NOTE The titles of the publications referred to in this standard are listed on the inside back cover.


Nomenclature, dimensions and tolerances for hand reamers, long flute machine reamers, machine chucking reamers, shell reamers, socket reamers, hand taper pin reamers, machine taper pin reamers and bridge reamers.