Cena s DPH / bez DPH
Hlavní stránka>BS ISO 8178-3:2019 Reciprocating internal combustion engines. Exhaust emission measurement Test procedures for measurement of exhaust gas smoke emissions from compression ignition engines using a filter type smoke meter
sklademVydáno: 2019-02-04
BS ISO 8178-3:2019 Reciprocating internal combustion engines. Exhaust emission measurement Test procedures for measurement of exhaust gas smoke emissions from compression ignition engines using a filter type smoke meter

BS ISO 8178-3:2019

Reciprocating internal combustion engines. Exhaust emission measurement Test procedures for measurement of exhaust gas smoke emissions from compression ignition engines using a filter type smoke meter

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
4650 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
465.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1395.00 Kč
Anglicky Tisk
Skladem
4650 Kč
Označení normy:BS ISO 8178-3:2019
Počet stran:20
Vydáno:2019-02-04
ISBN:978 0 580 99606 1
Status:Standard
Popis

BS ISO 8178-3:2019


This standard BS ISO 8178-3:2019 Reciprocating internal combustion engines. Exhaust emission measurement is classified in these ICS categories:
  • 13.040.50 Transport exhaust emissions
  • 27.020 Internal combustion engines
  • 13.040.40 Stationary source emissions

This document specifies a method for the measurement of smoke from exhaust gas of reciprocating internal combustion (RIC) engines at a steady state condition. The method evaluates the soot content by measurement of the blackening of a filter and derivation of black carbon mass concentration (mg/m3) from FSN. Where necessary, individual requirements may be specified for particular engine applications.

This document is applicable to RIC engines for mobile, transportable and stationary use, excluding engines for on-road transport of passengers and goods. It can be applied to engines for non-road use, e.g. for earth-moving machines, generating sets and for other applications. For engines used in machinery covered by additional requirements (e.g. occupational health and safety regulations, regulations for power plants) additional test conditions and special evaluation methods can apply.