Cena s DPH / bez DPH
Hlavní stránka>ASTM D8131_D8131M-23 - Standard Practice for Tensile Properties of Tapered and Stepped Joints of Polymer Matrix Composite Laminates
Sponsored link
Vydáno: 01.05.2023

ASTM D8131_D8131M-23 - Standard Practice for Tensile Properties of Tapered and Stepped Joints of Polymer Matrix Composite Laminates

Standard Practice for Tensile Properties of Tapered and Stepped Joints of Polymer Matrix Composite Laminates

Formát
Dostupnost
Cena a měna
Anglicky PDF
K okamžitému stažení
1335 Kč
Anglicky PDF Redline
K okamžitému stažení
1592 Kč
Anglicky Tisk
Skladem
1335 Kč
Označení normy:D8131_D8131M-23
Vydáno:01.05.2023
Status:Active
Počet stran:9
Sekce:15.03
Označení:adhesives; bonded joint; composite materials; joint properties; joint ultimate running force; joint ultimate tensile strength; repair; stepped joint; tapered joint; tension testing;
Popis

1.1 This test practice defines the procedure for determination of the tensile strength of a tapered or stepped joint of polymer matrix composite materials. It is applicable to secondary bonded or co-bonded laminates with either unidirectional plies or woven fabric reinforcements. The materials to be bonded may be different material systems. In the bondline, a separate adhesive material may or may not be used (example: adhesives may be used with a prepreg system or may not be used with a wet lay-up repair system). The range of acceptable test laminates and thicknesses is described in 8.2.1.

1.2 This practice supplements Test Method D3039/D3039M for tensile loading. Several important test specimen parameters (for example, joint length, ply overlaps, step depth, and taper ratio) are not mandated by this practice, however, these parameters are required to be specified and reported to support repeatable results.

1.3 Unidirectional (0° ply orientation) tape composites, textile composites, as well as multidirectional composite laminates, can be tested.

1.4 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.4.1 Within the text the inch-pound units are shown in brackets.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.