Cena s DPH / bez DPH
Hlavní stránka>ASTM D8211-21 - Standard Test Method for Hot Surface Ignition Temperature of Gases on Flat Surface
Sponsored link
Vydáno: 01.05.2021

ASTM D8211-21 - Standard Test Method for Hot Surface Ignition Temperature of Gases on Flat Surface

Standard Test Method for Hot Surface Ignition Temperature of Gases on Flat Surface

Formát
Dostupnost
Cena a měna
Anglicky PDF
K okamžitému stažení
1264 Kč
Anglicky PDF Redline
K okamžitému stažení
1498 Kč
Anglicky Tisk
Skladem
1264 Kč
Označení normy:D8211-21
Vydáno:01.05.2021
Status:Active
Počet stran:5
Sekce:05.05
Označení:flammability; hot surface ignition temperature; ignition; lower flammability limit; planchet; upper flammability limit;
Popis

1.1 This test method covers a means for the discrimination between gases, which will ignite or not ignite when impinged on a hot surface when that surface is heated to 800 °C (1472 °F) or greater for a period of 2 min in a non-confined environment.

1.2 This test method may be applied to any non-pyrophoric substance that is a gas or liquefied gas, particularly GHS category 1B gases, at ambient temperature and pressure.

1.3 This test method should be used subject to the limitations that no single fire hazard property such as flash point, auto-ignition temperature (AIT), or the performance under the conditions of the present method shall be used to describe or appraise the fire hazard or fire risk of a material, product, assembly, or system under actual fire conditions. Fire hazard properties measured under controlled laboratory conditions may nevertheless be employed to describe properly the response of materials, products, assemblies, or systems under said controlled conditions. Properties measured under controlled laboratory conditions may be used as elements of hazard or risk assessment only when such assessments takes into account all of the factors that are pertinent to the evolution of the fire hazard of a given situation.

1.4 This standard is used to provide a quantitative measure of a gas’s or liquefied gas’s realistic surface ignition temperature in a non-quiescent environment.

1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 9.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.