Cena s DPH / bez DPH
Hlavní stránka>ČSN EN ISO 15156-1 - Naftový a plynárenský průmysl - Materiály pro využití v prostředí obsahujícím H2S z těžby ropy a zemního plynu - Část 1: Obecné zásady pro výběr materiálů odolných proti tvorbě trhlin
Sponsored link
Vydáno: 01.06.2021
ČSN EN ISO 15156-1 - Naftový a plynárenský průmysl - Materiály pro využití v prostředí obsahujícím H2S z těžby ropy a zemního plynu - Část 1: Obecné zásady pro výběr materiálů odolných proti tvorbě trhlin

ČSN EN ISO 15156-1

Naftový a plynárenský průmysl - Materiály pro využití v prostředí obsahujícím H2S z těžby ropy a zemního plynu - Část 1: Obecné zásady pro výběr materiálů odolných proti tvorbě trhlin

Formát
Dostupnost
Cena a měna
Anglicky Tisk
Skladem
315 Kč
Označení normy:ČSN EN ISO 15156-1
Třídící znak:450032
Počet stran:24
Vydáno:01.06.2021
Harmonizace:Norma není harmonizována
Katalogové číslo:512080
Popis

ČSN EN ISO 15156-1

This document describes general principles and gives requirements and recommendations for the selection and qualification of metallic materials for service in equipment used in oil and gas production and in natural-gas sweetening plants in H2S-containing environments, where the failure of such equipment can pose a risk to the health and safety of the public and personnel or to the environment. It can be applied to help to avoid costly corrosion damage to the equipment itself. It supplements, but does not replace, the materials requirements given in the appropriate design codes, standards, or regulations. This document addresses all mechanisms of cracking that can be caused by H2S, including sulfide stress cracking, stress corrosion cracking, hydrogen-induced cracking and stepwise cracking, stress-oriented hydrogen-induced cracking, soft zone cracking, and galvanically induced hydrogen stress cracking. Table 1 provides a non-exhaustive list of equipment to which this document is applicable, including exclusions. This document applies to the qualification and selection of materials for equipment designed and constructed using load controlled design methods. For design utilizing strain-based design methods, see Clause 5. This document is not necessarily applicable to equipment used in refining or downstream processes and equipment.