Cena s DPH / bez DPH
Hlavní stránka>DD ISO/TS 15827:2007 Road vehicles. Test procedures. Evaluating small female dummy arm and forearm interactions with driver frontal airbags and side airbags
Sponsored link
sklademVydáno: 2007-06-29
DD ISO/TS 15827:2007 Road vehicles. Test procedures. Evaluating small female dummy arm and forearm interactions with driver frontal airbags and side airbags

DD ISO/TS 15827:2007

Road vehicles. Test procedures. Evaluating small female dummy arm and forearm interactions with driver frontal airbags and side airbags

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
4650 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
465.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1395.00 Kč
Anglicky Tisk
Skladem
4650 Kč
Označení normy:DD ISO/TS 15827:2007
Počet stran:20
Vydáno:2007-06-29
ISBN:978 0 580 52912 2
Status:Standard
Popis

DD ISO/TS 15827:2007


This standard DD ISO/TS 15827:2007 Road vehicles. Test procedures. Evaluating small female dummy arm and forearm interactions with driver frontal airbags and side airbags is classified in these ICS categories:
  • 43.020 Road vehicles in general

This Technical Specification describes test procedures for evaluating the effects of the interactions between driver frontal airbags or side airbags (excluding curtains) and small female arms.

This Technical Specification recommends dummies, procedures, instrumentation and test configurations that can be used for investigating the interactions that occur between a deploying airbag and a vehicle occupant. Driver frontal airbags deploy from the steering wheel and side airbags can deploy from the door, side trim panel, armrest, seat back or seat cushion. Occupants can range in size from young children to very large adults. However, the small adult female is considered to be the most at risk of arm injury from airbags. Therefore, this test procedure only addresses the small adult female occupant.

Recommended measurements are summarized in Clause 5. This Technical Specification encourages the use of a wide range of test configurations and conditions, while recognizing that the range of possible airbag interactions is essentially limitless and beyond testing capability.